SecuritySpy will automatically create and use a “self-signed” certificate for this purpose, which gets you up and running immediately and provides a fully encrypted connection. With some web servers this can be a complicated process, but we have designed SecuritySpy’s HTTPS server to be a simple as possible to set up: you simply enable the HTTPS option in the Web Server Settings window and SecuritySpy will do the rest for you. In order to set up any HTTPS server, an SSL certificate is required (SSL being the protocol that provides the security features to HTTPS). SecuritySpy has built-in support for HTTPS (HTTP Secure), which allows you to set up an encrypted web connection to your SecuritySpy server over the internet. You will also need to enable SecuritySpy’s HTTP web server (even though the connection to SecuritySpy is via plain HTTP, this connection is happening within the Mac itself – when data leaves the Mac to travel over the Internet, it is encrypted by the VPN/Tunnel software). Many tunnel/proxy providers apply data transfer limits, so you should take steps to minimise your bandwidth usage when accessing remotely, such as avoiding viewing live video in web browsers where streaming is done using high-bandwidth JPEG encoding, avoiding large file downloads, and generally using the connection sparingly.Īll installation and setup must be done on the Mac running SecuritySpy. On the other hand, with tunnel/proxy solutions, the data is always relayed via a central server. The two VPN solutions described below are “peer to peer” systems: a central server sets up the connection between clients, who then communicate directly (in the minority of cases where this is not possible, the system falls back to relaying data via the server). A number of these solutions are described below, with setup instructions. If you can’t use port forwarding for any reason, the solution is to set up a VPN or Tunnel (sometimes called a proxy) via a third-party service in order to access your system. Institutions with very strict network policies may have a blanket ban on allowing any kind of incoming connections from the Internet.ISP routers sometimes prevent users from setting port forwarding rules.your ISP router plus your own router), port forwarding configuration is difficult – the usual solution is to switch one of these routers to bridge/passthrough mode, but this isn’t always possible. If you have two routers between the Mac and the Internet (e.g. Port forwarding only works when your ISP gives you a true public IP address, which is not always the case, especially with cellular or satellite internet connections (e.g.However, some users may want to consider other methods for the following reasons: This method is great for most users, as it usually allows high-performance remote access with minimal configuration. This method allows direct incoming connections to SecuritySpy from the Internet, and is enabled by some configuration in your router (which, for most routers, SecuritySpy can do automatically). The usual way to set up remote access to our macOS CCTV software SecuritySpy running on your Mac is via port forwarding (see Installation Manual – Remote Access).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |